quick guide xconnect swiss made power
Introduction designed and assembled by studer in Switzerland EN Congratulations ! You just purchased the xconnect, a mounting frame to assemble a multi-xtender system. The xconnect will offer you a flexible and economical solution for high power systems based on inverters from the xth product range. Indeed, it will make the cabling of centralized, parallel, 3-phase or even parallel + 3-phase systems much easier.
General Information EN Exclusion of liability Studer disclaims all responsibility and liability for damage, costs or losses resulting from an installation that does not comply with the instructions, a faulty operation or inadequate maintenance. The use of studer equipment is in any case under the responsibility of the customer.
Cabling possibilities EN Cabling flexibility* The xconnect has been designed to offer a large range of cabling possibilities in order to best adapt to each environment. Four Ø 50 mm holes on each side of the frame enable input and output cabling (AC and/or DC) by either plugs/sockets or glands or installation channels. These inputs/outputs can likewise be carried out downwards via channels. If this later solution is chosen, the installer will take care not to seal the apertures down of the fixing frame.
Multi units Wiring | câblage | Verkabelung | cableado Multi xconnect systems It is possible to combine up to 9 xtender inverter-chargers (3 xconnect systems) allowing to reach a total power of 72kW. FR Système multi xconnect Il est possible de combiner jusqu’à 9 xtender (3 systèmes xconnect) permettant d’atteindre une puissance totale de 72kW.
Assembly | montage | Montage | montaje 10 4x 11
Assembly | montage | Montage | montaje 3x 12 14x 3x 6x 13
Assembly | montage | Montage | montaje 12x Maintenance and recycling 14 EN Maintenance and recycling Except for the periodic check of the connections (tightening, general condition), the rcc does not require any particular maintenance. To dispose of this product, please use the service for the collection of electrical waste and observe all obligations in force in the place of purchase.
Serial Number : Installed by : Date : Signature : Call our specialists +41 27 205 60 80 or visit studer-innotec.com/support Studer Innotec SA rue des Casernes 57 1950 Sion, Switzerland info@studer-innotec.com © All rights reserved Studer Innnotec SA – V1.
