quick guide next 3 swiss made power
Introduction EN Congratulations ! You are about to install and use a high-end equipment that will play a central role in the energy management of your battery-based system. The next3 is the first device of our new generation of smart battery inverter/charger with advanced functions. This next3 has been designed, manufactured, assembled and tested in our factory in Switzerland.
General Information EN Options & accessories : Exclusion of liability Studer disclaims all responsibility and liability for damage, costs or losses resulting from an installation that does not comply with the instructions, a faulty operation or inadequate maintenance. The use of studer equipment is in any case under the responsibility of the customer.
Mounting and installation 5x Storage and content Fixing and dimensions 1 60°C 2 17 -20°C 2x 720mm 80 0m m mm 600 72 kg min. 250mm min. 550mm min. 120mm Mounting place The next3 and batteries should only be installed by qualified personnel. min. 150mm min. 350mm 716mm 756mm min.
Wiring M8 T10 Solar PV (MPPT 1, MPPT 2) 2’ L1 L2 L3 N L1 L2 L3 N L1 L2 L3 N AC Source AC Loads AC Flex RTC battery + + • 2.5-6mm2 cable, Sunclix connector - Battery connection - • 4 x 70mm2 cable M8, 10Nm (Up to 4x95mm2 M8, 10Nm) BAT+, M8 Protection device (battery side) BAT-, M8 Protection device (PV side) Overvoltage protection, SPD : 4x900Vdc (1 per input) MPPT1 BATTERY string 1.1 * string 1.
Communication and power up Display 1 nx interface required in the communication bus Display system CAN BMS O Details for PV 1/20 PV production of MPPT input Solar excess 6.45 kW 34 A Next 3/5 PV input 1/2 RS 485i O = not connected T = connected 1 T T O O Sun today Total Energy Saved Fuel 3.4 hours 16.0 MWh 3504 l T Yesterday Today 67.0 6.7 Max. power 8 kW Voltage 15.
Configuring the next Multi units nx interface 3 phase and parallel combination (not yet available) Configuration wizard Remote control 1 Remote control Devices connected to battery 1 2 Devices Communicating battery 3 General Manufacturer name 4 AC Nominal capacity 5 Battery Cycle battery for solar use optimization To be set nx3 1600-48 st Yes To be set 0 Ah 6 Monitoring 7 Summary Updates Monitoring Step 2 of 2 Battery bank 1 of 1 specification User menu Dashboard/synoptic Dashboard Disp
Technical data Maintenance and recycling inverter Continuous Power nx3 16000-48 st IP 30 15000 VA Protection Class I Power 30min 16000 VA Power 5sec 30000 VA AC output voltage AC output frequency 230V Phase to Neutral / 400V Phase to Phase 50/60Hz solar Solar MPPT inputs PV input voltage 2 100 – 900 Vdc PV input startup voltage 350 Vdc PV max current 2 x 27 Adc PV power 14 Maintenance and recycling Except for the periodic check of the connections (tightening, general condition), the next
Serial Number : Installed by : Date : Signature : Call our specialists +41 27 205 60 80 or visit studer-innotec.com/support Studer Innotec SA rue des Casernes 57 1950 Sion, Switzerland info@studer-innotec.com © All rights reserved Studer Innnotec SA – V2.