User Manual

Printed in China
(SB2003BTBG/RB/RG/TE)
0222
SPECTRA MERCHANDISING INTERNATIONAL, INC. warrants this unit to be free from
defective materials or factory workmanship for a period of 1 year from the date of original
customer purchase and provided the product is utilized within the U.S.A. This warranty is not
assignable or transferable. Our obligation under this warranty is the repair or replacement of
the defective unit or any part thereof, except batteries, when it is returned to the SPECTRA
Service Department, accompanied by proof of the date of original consumer purchase, such as
a duplicate copy of a sales receipt.
You must pay all shipping charges required to ship the product to SPECTRA for warranty service.
If the product is repaired or replaced under warranty, the return charges will be at SPECTRA’s
expense. There are no other express warranties other than those stated herein.
This warranty is valid only in accordance with the conditions set forth below:
1. The warranty applies to the SPECTRA product only while:
a. It remains in the possession of the original purchaser and proof of purchase is demonstrated.
b. It has not been subjected to accident, misuse, abuse, improper service, usage outside the
descriptions and warnings covered within the user manual or non-SPECTRA approved
modications.
c. Claims are made within the warranty period.
2. This warranty does not cover damage or equipment failure caused by electrical wiring not in
compliance with electrical codes or SPECTRA user manual specications, or failure to provide
reasonable care and necessary maintenance as outlined in the user manual.
3. Warranty of all SPECTRA products applies to residential use only and is void when products
are used in nonresidential environment or installed outside the United States.
This warranty gives you specic legal rights, and you may also have other rights which vary
from state to state. TO OBTAIN SERVICE please remove all batteries (if any) and pack the unit
carefully and send it freight prepaid to SPECTRA at the address shown below. IF THE UNIT
IS RETURNED WITHIN THE WARRANTY PERIOD shown above, please include a proof of
purchase (dated cash register receipt) so that we may establish your eligibility for warranty
service and repair of the unit without cost. Also include a note with a description explaining how
the unit is defective. A customer service representative may need to contact you regarding the
status of your repair, so please include your name, address, phone number and email address
to expedite the process.
It is recommended that you contact SPECTRA first at 1-800-777-5331 or by email at
[e-mail] for updated information on the unit requiring service. In some cases,
the model you have may be discontinued, and SPECTRA reserves the right to o󰀨er alternative
options for repair or replacement.
SPECTRA MERCHANDISING INTERNATIONAL, INC.
4230 North Normandy Avenue,
Chicago, IL60634, USA.
1-800-777-5331
To register your product, visit the link on the website below to enter your information.
http://www.spectraintl.com/wform.htm
E - 6
E - 9
AUX IN OPERATION
This unit provides an auxiliary audio signal input jack for connecting external audio devices like
MP3 players, CD players, smart phones and iPods (except iPod shu󰀪e 3rd generation) to listen
to your external source through the speakers of this system.
1. You need an audio cable (not included) with one 3.5 mm stereo plug on each end of the cable.
2. Plug one end of the cable into the AUX-IN jack (#11) located on the right hand side of the
unit and the other end of the cable into the Line-out Jack or Headphone Jack of your external
audio device.
3. Turn on the external audio device.
4. Turn on your unit and it will switch to AUX mode automatically.
5. The volume level can now be controlled through the volume control of your radio. Operate all
other functions on the auxiliary device as usual.
6. Switch the ON/OFF SWITCH (#3) to OFF position to turn o󰀨 the unit when you nish listening.
Notes:
• If you connected the Line-out Jack of your external device then you only need to adjust the
volume control of this unit. If you connected the Headphone Jack of your external device then
you may need to adjust both the volume control of your external device and the volume control
of this unit to nd the most desirable volume setting.
• Remove the audio cable from AUX IN jack (#11) when you nish listening. Don’t forget to switch
o󰀨 the power on your external device as well.
E - 7
E - 10 E - 11
E - 8
SPECIFICATIONS
POWER SUPPLY: AC - 120V 60Hz, 6W
DC - 4 x1.5V type R14/ UM-2/ “C” size batteries (not included)
FREQUENCY RANGE: FM 88 - 108 MHz
AM 530 - 1700 KHz
BLUETOOTH
Bluetooth Version: V5.0+EDR
Bluetooth: 2.402-2.48GHz
RF Output Power: +2 dBm
Working Distance: Up to 10 meters (32.8 feet) measured in open space (wall and structures
may a󰀨ect range of device).
The Bluetooth
®
word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and
any use of such marks by Spectra Merchandising Intl, Inc. is under license. Other trademarks
and trade names are those of their respective owners.
TROUBLESHOOTING GUIDE
1 YEAR LIMITED WARRANTY AND SERVICE
VALID IN THE U.S.A. ONLY
If you experience di󰀩culties in the use of this music system, please check the following or call
1-800-777-5331 for Customer Service.
Symptom Possible Cause Solution
Noise or sound
distorted on AM
or FM broadcast.
- Station not tuned properly for AM
or FM.
- FM: Telescopic antenna is not
extended.
- AM: The bar antenna is not positioned
correctly.
- Retune the AM or FM broadcast
station.
- Fully extend the FM telescopic
antenna.
- Reposition the unit until the best
reception is obtained.
AM or FM no
sound.
- Unit not set to AM or FM band.
- Volume at minimum.
- Switch the function selector to AM
or FM position.
- Increase Volume.
No sound on
Bluetooth
- The unit is not linked with the cell
phone.
- Speaker placement out of range.
- Volume set too low.
- Go through “Bluetooth Operations”
process to link the speakers.
- Relocate the speaker within
Bluetooth operating range.
- Rotate the volume knob to turn the
sound level up.
Sound is distorted
on Bluetooth
- Volume level is set too high.
- Sound source is distorted.
- If the cell-phone original sound
source quality is poor, distortion
and noise are easily noticed with
high-power speakers.
- If you are using an external sound
source like older generation of iPod,
try reducing the output volume on
the device itself.
USING HEADPHONES (NOT INCLUDED)
Inserting the plug of your headphones into the HEADPHONES JACK (#10) will enable you to listen
to the Radio music in private. When using headphones, the Built-in Speakers will be disconnected.
CAUTION:
• Avoid excessive volume levels for long period of time when using the earphones. Prolonged
use at high levels may impair your hearing.
• Keep the volume at a reasonable level even if your headset is an open-air type designed to
allow you to hear outside sounds. Please note that excessively high volume may still block
outside sounds.
BLUETOOTH OPERATION
Pairing a Bluetooth enabled device with the SB2003BT.
1. Use the FUNCTION SELECTOR (#2) to select the Bluetooth function.
2. Switch the ON/OFF SWITCH (#3) to ON position to turn on the unit.
3. The BLUETOOTH INDICATOR (#6) below the FUNCTION SELECTOR (#2) will turn on
and ash.
4. Turn on the Bluetooth function of your device and enable the search or scan function to nd
the SB2003BT.
5. Select SB2003BT from the device list when it appears on your device screen. If required,
enter the pass code “0000” to pair (link) SB2003BT with your device.
6. If you are pairing (linking) your computer to the speaker using Bluetooth, you may need to
set the SB2003BT as your computer’s default sound device.
7. After pairing SB2003BT with your Bluetooth device successfully, the BLUETOOTH INDICATOR
(#6) will light steadily.
8. If you want to change the SB2003BT to pair with another Bluetooth device, turn o󰀨 the
Bluetooth on the paired Bluetooth device, the BLUETOOTH INDICATOR (#6) of SB2003BT
will change to ashing slow, repeat step 4-5 above.
Note: The SB2003BT may automatically reconnect to a previously linked device that is in range.
Now you can play music from your Bluetooth device wirelessly to SB2003BT.
1. Selecting your favorite song, press Play/Pause Button on your Bluetooth device to play or
pause the Bluetooth device playback.
2. Slowly adjust both the volume controls of your SB2003BT and your Bluetooth device until
you reach a comfortable listening level.
Notes:
1. Refer to the manual of your cell phone, tablet PC, computer or other Bluetooth enabled devices
for Bluetooth operation since it may vary from model to model.
2. If your Bluetooth enabled device does not support A2DP prole, it will not play the music
through the speaker, even if paired (linked).
3. Remember to turn o󰀨 the SB2003BT when you have nished listening.
4. Don’t forget to switch o󰀨 the power of your Bluetooth device as well.
LISTENING TO THE RADIO
1. Use the FUNCTION SELECTOR (#2) to select the AM or FM band.
2. Switch the ON/OFF SWITCH (#3) to ON position to turn on the unit.
3. Use the TUNING KNOB (#4) to tune to your desired radio station.
4. Adjust the VOLUME CONTROL (#1) to the desired volume level.
5. Switch the ON/OFF SWITCH (#3) to OFF position to turn o󰀨 the unit when you nish listening.
TIPS FOR BEST RECEPTION:
AM - The AM antenna is located inside the cabinet of the unit. If AM reception is weak, change
the position of unit until the internal antenna picks up the strongest signal.
FM - To ensure maximum FM tuner reception, fully extend the FM TELESCOPIC ANTENNA
(#8) and rotate it for the best FM radio reception.
POWER SUPPLY
IMPORTANT:
• Be sure that the batteries are installed correctly. Wrong polarity may cause permanent damage
to the unit.
• For best performance and longer operating time, we recommend the use of alkaline batteries.
• If the unit is not to be used for an extended period of time, remove all the batteries. Old or
leaking battery can cause damage to the unit and will also void the warranty.
• Do not dispose of battery in re. Battery may leak or explode.
• Battery shall not be exposed to excessive heat, such as sunshine, re or the like.
CAUTION:
Danger of explosion if batteries are incorrectly replaced. Replace only with the same or
equivalent type.
Note:
When the unit is plugged into an AC outlet, it automatically switches to AC power source even
if batteries are installed.
The SB2003BT can be operated from the following power sources:
AC: 120V
60Hz
DC: 4 x 1.5V , battery type R14/ UM-2/ “C” size (not included)
CONNECTING TO AC POWER AND INSTALLING BATTERIES
1. Insert the plug of Power Cord into a standard wall outlet with a constant AC power supply.
2. Install 4 fresh alkaline batteries into the battery compartment following the polarity diagram
inside. Use only the specied size and type of batteries. To open the battery door, press on
the arrows rmly and then slide downward.
R-3972T IB STUD 001 REV1 GB.indd 2 2022/2/11 10:33:11