Owner's Manual

4
• If the unit is not to be used for a long period of time, make sure that all power sources are
disconnected from the unit. Remove all batteries from the battery compartment.
• This unit employs a laser. The use of controls or adjustment or performance of procedures other
than those specified here may result in exposure to hazardous radiation.
Caution:
- Any use of the controls or performing any of the procedures in a way other than those specified
herein may result in hazardous radiation exposure.
- This unit should not be adjusted or repaired by anyone except qualified service personnel.
ON PLACEMENT
• Do not use the unit in places which are extremely hot, cold, dusty or humid.
• Place the unit on a flat and even surface.
• Do not restrict the air-flow of the unit by placing it in a place with poor ventilation, by covering it
with a cloth or by placing it on a carpet.
ON CONDENSATION
• When left in a heated room where it is warm and damp, water droplets or condensation may form
inside the unit.
• When there is condensation inside the unit, the unit may not function normally. Let it stand for 1
to 2 hours before turning the power on, or gradually heat the room up and dry the unit before use.
Should any trouble occur, disconnect the AC Adapter and refer servicing to qualified
personnel.
KEEP YOUR SB2165 WITHIN ACCEPTABLE OPERATING TEMPERATURES
The built-in rechargeable battery should not be exposed to excessive heat such as sunshine, fire
and humidity. Use this unit where the ambient temperature is between 32ºF to 113ºF (0ºC and
45ºC). Using this unit in very hot conditions can permanently shorten battery life and deform the
enclosure which is not covered by the warranty. Store this unit where the temperature is between
-4º to 140ºF (–20Cº and 60ºC). Do not leave the unit in your car because temperatures in parked
cars can exceed this range.
Protect your SB2165 from higher temperature conditions and activities that might cause
damage to the unit or affect performance
• Do not leave this unit in direct sunlight.
• Do not leave this unit in a car on a hot day.
• Do not use certain features in hot conditions or direct sunlight for an extended period of time.
PROTECT YOUR FURNITURE
This system is equipped with non-skid rubber ‘feet’ to prevent the product from moving when you
operate the controls. These ‘feet’ are made from non-migrating rubber material specially formulated
to avoid leaving any marks or stains on your furniture. However certain types of oil based furniture
polishes, wood preservatives, or cleaning sprays may cause the rubber ‘feet’ to soften, and leave
marks or a rubber residue on the furniture.
To prevent any damage to your furniture we strongly recommend that you purchase small
self-adhesive felt pads, available at hardware stores and home improvement centers everywhere and
apply these pads to the bottom of the rubber ‘feet’ before you place the product on fine wooden
furniture.