Owner's Manual

13
AUX IN OPERATION
You can play other music sources (iPod, MP3 or other digital audio players) through the speakers of
the unit by connecting the AUX IN JACK to your external player’s audio out jack or headphone jack.
1. Plug one end of a 3.5mm audio cable (not included) into the AUX IN JACK and the other end of
the cable to the headphone jack of your digital audio player.
2. Slide the FUNCTION switch to the CD/USB/AUX position.
3. Turn on and start playing the external device you plugged into the AUX IN JACK.
4. Slowly adjust both the volume controls of your unit and the external device until you reach a
comfortable listening level.
5. Turn off both the external audio player and this unit after use. Unplug the audio cable from AUX
IN jack
Notes:
• If you connect the unit to the Line-Out Jack of your external device, you only need to adjust the
VOLUME CONTROL of your unit. If you connect to the Headphone Jack of your external device,
you may need to adjust both the volume controls of your external device and the unit to obtain
the desirable listening level.
• Remember to turn off the unit and unplug the AUX in cable from the unit when you have finished
listening. Don't forget to switch off the power of your external audio device as well.
USE HEADPHONES (NOT INCLUDED)
LLEEDD LLIIGGHHTT SSHHOOWW
RREESSEETTTTIINNGG TTHHEE UUNNIITT
Inserting the plug of your stereo headphones (not included) into the headphone jack located on the
top panel will enable you to listen in private. When using headphones, the speakers will be discon-
nected.
Read this Important Information before Using Your Headphones
1.) Avoid extended play at very high volume as it may impair your hearing.
2.) If you experience ringing in your ears, reduce the volume or shut off the unit.
3.) Keep the volume at a reasonable level even if your headset is an open-air type designed to allow
you to hear outside sounds. Please note that excessively high volume may still block outside
sounds.
- To turn off the LED light show, press the LIGHT SHOW button.
- To turn on the LED light show, press the LIGHT SHOW button once again.
Note: If the brightness is glaring, turn on room lights or turn off LED light show.
1. Do not subject the unit to excessive force, shock, dust or extreme temperature.
2. Do not tamper the internal components of the unit.
3. Clean your unit with a dry cloth. Solvent or detergent should never be used.
4. Avoid leaving your unit in direct sunlight or in hot, humid or dusty places.
5. Keep your unit away from heating appliances and sources of electrical noise such as fluorescent
lamps or motors.
6. If drop-outs or interruptions occur in the music during CD play, or if the CD
fails to play at all, its bottom surface may require cleaning. Before playing,
wipe the disc from the center outwards with a good soft cleaning cloth.
In case of malfunction due to electrostatic discharge, reset the unit by slide the FUNCTION switch to
POWER OFF position to reset the unit. Wait for 30 seconds before power on the unit again.
CARE AND MAINTENANCE