Owner's Manual

9
CD OPERATION
PLEASE READ THIS IMPORTANT INFORMATION:
CD mechanisms used in devices like this are designed to fully read all commercial CDs. They will also read
self-compiled CD-R/CD-RW discs but it may take up to 10 seconds for playback to start. If playback does
not start, it is likely due to the quality of the CD-R/RW disc and/or the compatibility of the CD compilation
software. Manufacturer is not responsible for the playback quality of CD-R/RW discs.
Do not attach a label or seal to either side of the CD-R/RW disc. It may cause a malfunction.
(Make sure AUX cable is not plugged into the AUX IN jack).
1. Slide the FUNCTION SWITCH to CD/USB/AUX position, the display will show “- - -“ briefly. If no CD
has been loaded in the CD compartment, LED display will change to show “no”.
2. Push the “OPEN/CLOSE” mark on the CD Door to open it.
3. Carefully load an audio CD with its label side upward in the CD compartment then push the
“OPEN/CLOSE” mark on the CD Door to close the CD door.
4. The player will start reading TOC of the disc, total number of tracks on the CD will appear on the LED
DISPLAY after a few seconds.
5. Press the PLAY/PAUSE button to start playing.
6. Adjust the MASTER VOLUME knob to obtain the desired sound.
7. To temporarily stop playing, press the PLAY/PAUSE Button. The play/pause indicator will be
flashing. To resume playing, press the PLAY/PAUSE Button again. The play/pause indicator will
be solid on.
8. You can skip up or down to a specific track number by pressing the SKIP BACKWARD button or
SKIP FORWARD button. The LED Display will indicate the correct track number selected.
9. To locate a particular section within a track, press and hold the / button until the section is
found.
10. To stop playing, press the STOP button.
11. Slide the FUNCTION SWITCH to POWER OFF position to turn off the unit after listening.
+10 button control
Press the +10 button once to advance the music search by increment of 10 tracks.
REPEAT MODE
Repeat 1
To repeat the current track, press the REPEAT BUTTON once, the REPEAT INDICATOR will flash in LED
display. The track will continue to play until the repeat function is turned off.
Repeat All
To repeat all the tracks, press the REPEAT BUTTON twice, the REPEAT INDICATOR will be solid on. All
the tracks on the disc will be played repeatedly.
To Cancel Repeat Function: Press the REPEAT BUTTON until REPEAT indicator goes off from LED
display.
PROGRAM OPERATION
This function allows the tracks to be played in a programmed sequence.
NOTE: Programs can only be set in STOP mode.
1. In CD stop mode, press REPEAT/PROGRAM button, the PROGRAM indicator will flash and Program
Number “P01” will show on LED display.
2. Press the SKIP or button to select the desired track. The track number “1” will blink on the LED
display to prompt for input.
3. Press the PROGRAM button to confirm the selection. Program Number advances to “P02”.
4. Repeat step 2 to 3 to program up to maximum of 20 tracks.
5. When maximum of 20 tracks have been programmed, the LED display will show “FUL” to indicate
program is full.
6. When you have completed programming, press the PLAY/PAUSE button to start playing. Both
PROGRAM and PLAY/PAUSE indicators are lighting steadily.
7. To cancel programmed play, press the STOP button twice. PROGRAM indicator goes off.