User Manual
Table Of Contents
- Strymon Flint User Manual
- Knobs and Switches
- Rear Panel I/O and Control
- Live Edit Functions
- Power Up Modes
- External Control
- MIDI Functionality
- MIDI Specifications
- Factory Reset
- Features
- Specifications
- Appendix 1: Sample Settings
- Appendix 2: Power Up Modes Quick Reference
- Appendix 3: Live Edit Controls Quick Reference
- Strymon Non-Transferable Limited Warranty
pg 19
Flint - tremolo & reverb
External Control
Expression Pedal Setup
Use a TRS expression pedal to control the knobs of Flint� (By default, the
Expression pedal is configured to control Flint’s Speed knob�)
1 Configure the EXP/MIDI jack for Expression mode� (See page 17 for
configuration instructions�)
2 Connect an expression pedal to the EXP/MIDI jack of Flint using a
TRS cable�
RIGHT IN LEFT OUT RIGHT OUT EXP
MIDI IN
USB
MIDI OUT
3 Press and hold both footswitches until both LEDs blink GREEN�
4 Rock the expression pedal to the HEEL position� Only the TREMOLO
ON LED will blink GREEN�
5 Set the knob(s) you would like to control to the desired settings for the
HEEL position of the expression pedal� Only the TREMOLO ON LED
will turn RED�
6 Rock the expression pedal to the TOE position� Only the REVERB ON
LED will blink GREEN�
7 Set the knob(s) you would like to control to the desired settings for the
TOE position of the expression pedal� Only the REVERB ON LED will
turn RED�
8 Press either footswitch to exit and store your expression pedal setup�
NOTE: Your expression pedal assignment is saved per Favorite setting or per
MIDI preset�
NOTE: If Flint is set to respond to MIDI EXPRESSION and the EXP/MIDI jack
is set to MIDI mode, you can send MIDI CC# 100 with values 0 (heel) to 127
(toe) to perform the expression pedal setup�