User Manual
Table Of Contents
- Strymon El Capistan User Manual
- Knobs and Switches
- Rear Panel I/O and Control
- Live Edit Functions
- Power Up Modes
- External Control
- MIDI Functionality
- MIDI Specifications
- Factory Reset
- Features
- Specifications
- Appendix 1: Sample Settings
- Appendix 2: Power Up Modes Quick Reference
- Appendix 3: Live Edit Controls Quick Reference
- Strymon Non-Transferrable Limited Warranty
El Capistan - dTape Echo
pg 17
Power Up Modes
Spillover Mode
Setting El Capistan to Spillover mode allows the echo repeats of the
currently selected preset to “spill” into bypass or the next loaded preset�
NOTE: Because of the buffer architecture, the current preset must be active
for at least 5 seconds before Spillover between presets will be operational�
Spillover is available immediately when bypassing the effect�
1 Press and hold the ON footswitch while powering up El Capistan�
Once both LEDs flash, release the footswitch�
2 Turn the TAPE AGE (SPILLOVER MODE) knob to turn Spillover mode
on or off� Both LEDs will change color to indicate the current status
as you turn the knob�
• Spillover mode Off: AMBER (default)
• Spillover mode On: PURPLE
3 Press either footswitch to store the Spillover mode setting and begin
using El Capistan�
NOTE: The Spillover mode setting persists across power cycles and is not
saved per preset�