User Manual
Table Of Contents
- Strymon Deco User Manual
- Knobs and Switches
- Rear Panel I/O and Control
- Live Edit Functions
- Power Up Modes
- External Control
- MIDI Functionality
- MIDI Specifications
- Factory Reset
- Features
- Specifications
- Appendix 1: Sample Settings
- Appendix 2: Power Up Modes Quick Reference
- Appendix 3: Live Edit Controls Quick Reference
- Strymon Non-Transferable Limited Warranty
pg 31
Deco - tape saturation & doubletracker
Configuring Deco to Use MIDI (cont.)
STEP 3 SET MIDI OUT MODE
1 Press and hold the TAPE SATURATION ON footswitch while connect-
ing power to the pedal� Once both LEDs flash, release the footswitch�
2 Turn the TONE knob to select what kind of MIDI data is sent from
Deco to other MIDI devices� Both LEDs will flash momentarily to indi-
cate status�
• OFF: RED (default) - No MIDI messages are sent out of Deco�
• THRU: BLUE - Incoming MIDI messages are sent to the MIDI Out
without any additional MIDI messages generated by Deco�
• SEND CC PC OTHER: WHITE - MIDI CC, PC, and SysEx messages
generated by Deco are all sent to the MIDI Out�
• SEND CC OTHER: GREEN - MIDI CC and SysEx messages gener-
ated by Deco are sent to the MIDI Out�
• SEND PC OTHER: PURPLE - MIDI PC and SysEx messages gener-
ated by Deco are sent to the MIDI Out�
• SEND OTHER: AMBER - SysEx messages generated by Deco are
sent to the MIDI Out�
3 Press either footswitch to store the MIDI OUT mode and exit�