User Manual

pg 10
blueSky - reverberator
Power Up Modes
Bypass Mode
Setting blueSky to Buffered Bypass mode preserves the high frequency
response of your instruments signal through your pedal chain and
long cable runs�
1 Press and hold the ON footswitch while powering up blueSky� Once
both LEDs flash, release the footswitch�
2 Turn the MIX (BYPASS MODE) knob to choose between True Bypass
or Buffered Bypass modes� The ON LED will change color to indicate
the current status as you turn the knob�
True Bypass: GREEN (default)
Buffered Bypass: RED
3 Press either footswitch to store the Bypass Mode and begin using
blueSky
NOTE: The Bypass Mode setting persists across power cycles and is not
saved per preset�