User Manual

MAGNETO - Four Head dTape Echo & Looper
®
pg 19
DIP Switches
DIP switches are located on the back of the unit.
Adjusting these switches will likely require Magneto
to be removed from the rack.
S1 - FEEDBACK CV MODE:
ON: Allows CV trigger control of the FEEDBACK ON/
OFF buttons when transport CV jack is plugged in
while Transport LED is OFF. Also provides CV control
of the Transport controls when a CV jack is plugged
in when Transport LED is RED. Each transport CV can
be assigned to either Transport or Feedback ON/OFF.
OFF: Standard CV control of transport whenever
transport CV jacks are plugged in. (DEFAULT is OFF.)
S2 - DUAL SPLIT MODE:
ON: Selects Dual Split mode where LEFT audio IN/
OUT is a mono four head tape delay, and RIGHT audio
IN/OUT is mono spring reverb.
OFF: Standard stereo IN/OUT with the delay signal
feeding into the Spring reverb. (DEFAULT is OFF.)
ON
1 2
LEFT IN – Delay Input
LEFT OUT – Delay Output
RIGHT IN – Reverb Input
RIGHT OUT – Reverb Output