User Manual

TimeLine - User Manual
®
pg 22
Globals Menu (continued)
PEDAL
EXP input mode: Confi gures the EXP input to use an Expression Pedal, an external TAP footswitch, or
a Strymon MultiSwitch.
TAP
BANK
PRESET
LOOPER
NORMAL
Dry Signal: Turns the dry signal on or off. This is sometimes useful in a parallel effects loop
when an effect level is necessary.
KILL
- dry signal is muted allowing the MIX control to be used as an effect level
OFF
Spillover: Allows the wet delay signal of a currently selected preset to “spill” into the
next selected preset. IMPORTANT: Because of the delay buffer architecture,
the current preset must be active for at least 5 seconds before spillover will be
operational.
ON
OFF
Preset Names: Enables or disables the display of preset names when displaying the current
bank. If set to ON or SCROLL, when incrementing through banks with the VALUE
encoder, the bank number will be displayed with 2 digits followed by the fi rst 3
characters of the preset name.
ON
SCROLL
- bank numbers are displayed instead of preset names
- for use with Expression Pedal
- for use with external TAP footswitch, or MultiSwitch for tap and preset select
- for use with MultiSwitch to select preset banks
- for use with MultiSwitch to select presets
- for use with MultiSwitch to control Looper functions
- the fi rst 6 characters of the preset name are displayed
- the preset name will scroll once completely through it’s 16 characters
then settle on the fi rst 6 characters
Please refer to the MultiSwitch user manual for detailed MultiSwitch setup
information: www.strymon.net/support/multiswitch
BNK 1-99
Bank Scroll: Sets the maximum bank number to scroll to.