User Manual

Deco - Tape Saturation & Doubletracker User Manual
®
pg 9
Input Modes
HOLD BOTH AT POWER UP while turning the
LAG TIME knob to set Input Mode
Deco provides two input modes to tailor the range of Tape Saturation for
your input signal. To change this mode, hold down both Saturation Bypass
and Doubletracker Bypass switches while powering up. While holding
down, turn the Lag Time knob to one of two ranges shown below.
NORMAL MODE
Set here to use Normal Mode, which is
calibrated for a wide range of guitar and
instrument level inputs. Normal Mode is
recommended when using Deco on your
pedalboard in front of an amp.
STUDIO MODE
Set here to use Studio Mode, which tailors the
Saturation range to be best suited for hotter input
signals. Studio Mode is recommended when
using Deco with DAWs, mixer inserts, line level
synths, or hot effects loops in guitar rigs.