User Manual

MultiSwitch Plus - Extended Control
pg 6
TimeLine, BigSky & Mobius Mode
Release the footswitches. The LEDs on
MultiSwitch Plus will flash GREEN when
configuration is complete.
All outputs carry the same signal in this mode.
Enter TimeLine, BigSky and Mobius Mode by
holding down the B and C footswitches at the
same time while connecting the TRS cable
to MultiSwitch Plus. The B and C LEDs will
flash RED to confirm the selection.
Connect the included TRS cable to the EXP
jack of the pedal you wish to control.
3
2
1
This mode adds expanded preset selection control for TimeLine, BigSky, and
Mobius and dedicated Looper controls for TimeLine.
May require firmware update. Check the Compatibility Chart on pg.15 for details.
NOTE: MultiSwitch Plus LEDs remain unlit in
this mode. The TimeLine, BigSky and Mobius
are not capable of bidirectional communication
which is required to support MultiSwitch Plus
LED functionality.
Check the Appendix for instructions on how
to configure the connected pedal for use in
this mode.
4
A
B
C
A B
C
+ +
EXP