User Manual

DIG - Dual Digital Delay User Manual
®
pg 10
Holding down the TAP footswitch enables Circular
Repeats, where both delay lines maintain a static
volume and repeat continuously until the TAP
footswitch is disengaged. At this point, all previous
settings will be restored.
The 1/4” input can be set for either mono input or
TRS stereo input. The pedal ships in mono input
configuration from the factory. Here’s how to
change the input configuration:
Remove the back cover of your pedal. On the left
side of the circuit board, you’ll see a jumper that
can be set in two positions. Place the jumper on the
left 2 pins for TRS stereo input. Place the jumper
on the right 2 pins for mono input.
In order to use the TRS stereo input,
you’ll need a TRS stereo input adapter
like the one shown below.
Mono inputStereo input
Circular Repeats
TRS Stereo Input
RING
RIGHT 1/4” INPUT
LEFT 1/4” INPUT
TIP
SLEEVE TIP
RING
Press and hold to engage the
Circular Repeats feature.
Release to return the controls
to their previous settings.