User Manual
20
Footswitch Button Mapping Screen
Access this screen by selecting the ADVANCED icon on
the FOOTSWITCH ADJUSTMENTS screen. The default
functions of each footswitch pedal and button can be
reprogrammed to accommodate the surgeon's prefer-
ences.
Depending on the type of handpiece displayed at the top
of the screen, one or more of the following options will be
available on this screen.
The DIRECTION, OP MODE, and RUN MODE icons
correspond respectively to the two largest footswitch
pedals. Press each icon to scroll through the follow-
ing function options. And stop on the desired func-
tion setting.
DIRECTION
Pedal is turned off.
Footswitch defaults to the settings selected on
the handpiece screen.
Forward: Pedal setting default is overridden.
Pedal will provide handpiece rotation in the
forward (clockwise) direction.
Reverse: Pedal setting default is overridden.
Pedal will provide handpiece rotation in the
reverse (counterclockwise) direction.
OP MODE
Footswitch defaults to the settings selected on
the handpiece screen.
Handpiece operates in the high speed range.
Handpiece operates in the low speed range.
Handpiece operates in oscillate mode.
RUN MODE
Footswitch defaults to the settings selected on
the handpiece adjust screen.
Variable: Variable speed control. Speed
responds to varying degrees of pressure on the
footswitch.
Nonvariable: Handpiece operates at a
constant speed level determined by the
maximum speed selected from the handpiece
screen.
One touch: The one touch function is similar to
an on/off toggle. Tap the footswitch to operate
the handpiece at the maximum speed selected
from the handpiece screen. Tap any trigger
device again to stop operation.
BUTTON FUNCTION
The I, II, and III icons correspond to the three small pads
across the top of the footswitch.
Button Function displays the active function of the
corresponding button.
Use the arrow icons to scroll through the functions and
stop on the desired setting.
See Button Functions listed on next page.
Reset all: Press to return all pedals and
buttons back to their default setting.
Reset: Press to return the selected footswitch
button back to its default setting.