User's Manual
Table Of Contents
- User’s Guide
- This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- 1. This device may not cause harmful interference
- 2. This device must accept any interference received, including interference that may cause undesired operation.
- Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
Page 2 of 3
Finally, the MR PCBA contains an integrated RFID antenna designed to read passive HF RFID smart tags.
The integrated RFID antenna is located on the mother board, Stryker PN 0590-085-340.
Technical Data:
Mechanical Data:
Housing: None provide, bare PCBAs only; installed within the Neptune 3 Rover
Dimensions: (W x H x D): 3.31inch x 0.62inch x 4.82inch (84.07mm x 15.75mm x 122.43mm)
Pwr/Comm Connector: 12 Pin-Connector, Samtec, IPL1-106-01-L-D-RA-K, custom wire configuration
Weight: 2.7 oz. (77g)
Electrical Data:
Supply Voltage: 17 V
DC
to 41.2 V
DC
Current Draw: 1.0A Max at 36 V
DC
Roving Mode or 0.5A Max at 18 V
DC
Docking Mode
Power Consumption: 36W Roving Mode or 9W Docker Mode
Interfaces: RS485 – Level, 115.2 kbps, Proprietary Communication Protocol
Processor: Microchip dsPIC 33EP256MU810 and Fujitsu MB90F562B
Main RFID Functional Properties:
Reader: Ability to detect, read, and write to passive HF RFID smart tags
Operating Frequency: 13.56 MHz
Distance: Short communication range, 1.5” or less
Ambient Conditions:
Temperature Range: 0°C - 70°C
Humidity: 5 – 95% non-condensing