User's Manual

Table Of Contents

EN-30

Selecting Between RF and Shaver Modes

To select the appropriate mode, do one of the following:

• Press

on the Crossre interface. e interface will toggle

between modes.

• Pressthemodebuttononthefootswitch.

• Pressanybuttononthedesiredhandpiece.

Adjusting Power and Speed Settings

Use the

buttons on the console to manually adjust the power or speed

setting for the active handpiece.

Note: Forward and reverse settings are adjusted independent of each other.

Adjusting settings in one mode will not aect the other.

Note: In RF mode, power can also be adjusted with the buttons on the handpiece

or footswitch.

Note: To switch between  and  in RF mode, use the buttons on the

handpiece or footswitch.

Note: In shaver mode, the console uses radio frequency identication () to

automatically detect which type of disposable attachment is connected to the

handpiece. Upon recognition, the console adjusts to an optimal preset cutting

speed, direction, and power.