Users Manual

Nest Case V1

Instructions for Use

16. Regulatory Markings

The CE mark is a registered trademark of the European Community. This CE

mark shows that the product complies with all the relevant European Legal

Directives.

ICES/NMB-003(B)

This product complies with the Canadian ICES-003(B).

Cet appareil est conformer a la norme NMB-003(B) du Canada.

This product is tested and certified by Nemko and complies with IEC/EN

61010-1, UL 61010-1 and CSA C22.2 No. 61010-1

This product complies with the WEEE Directive (2012/19/EU) marking

requirement. This product label indicates that you must not discard this

electrical or electronic product in general waste.

17. Compliance Statement

This device complies with part 15 of the FCC Rules. Operation is subject to the following two

conditions: (1) This device may not cause harmful interference, and (2) this device must accept

any interference received, including interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential installation. This equipment generates,

uses and can radiate radio frequency energy and, if not installed and used in accordance

with the instructions, may cause harmful interference to radio communications. However, there

is no guarantee that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or television reception, which can be

determined by turning the equipment off and on, the user is encouraged to try to correct the

interference by one or more of the following measures:

• Reorient or relocate the receiving antenna

• Increase the separation between the equipment and receiver

• Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected

• Consult STRYDE for help

Changes or modifications to the equipment not expressly approved by the party responsible

for compliance could void the user's authority to operate the equipment.