Users Manual

Initialisation Device
Instructions for Use
Copyright © 2020 STRYDE All rights reserved
4
1. Safety Information
The following general safety precautions must be observed during all phases of operation of
this product.
Do not use the device if it appears damaged or defective
Do not dismantle or try to repair a broken unit
Do not perform any unauthorized modification or change to the
device
Do not expose to excessive heat or flames
Dropping the device and other mechanical abuse may cause damage to
sensor, electronics and mechanical parts
The device is sealed and not serviceable
Failure to comply with these precautions or with specific warnings elsewhere in this manual
violates safety standards of design, manufacture, and intended use of the product. STRYDE
assumes no liability for the customer’s failure to comply with these requirements.
For further information on safety, please refer to the STRYDE Operation Support Product File.
2. Certifications
This product is designed for use in compliance with, and is certified according to, the following
certification rules:
FCC Part 18.305
FCC Part 15.209
FCC Part 15C Intentional radiators, Frequency Hopping Transmitters / Digital Transmission
Systems
ETSI EN 303 417 V1.1.1 (2017-09) ETSI EN 303 446-1:V1.2.0 (draft – 2019-03)
FCC KDB 680106 D01 RF Exposure Wireless Charging Apps v02
FCC Part 1.1310 Radiofrequency radiation exposure limits
ETSI EN 300 328 V1.1.1 (2017-09), ETSI EN 303 413 V1.1.1 (2017-09)
EN 301 489-01:V2.2.0, EN 301 489-03:V2.1.1, EN 301 489-17:V3.2.0, EN 61000-6-
1:2007, EN 61000-6-3:2007 + A1:2011
IEC 61010-1:2010, IEC 61010-1:2010/AMD1:2016
Industry Canada ICES-003, Issue 6 – Information Technology Equipment (ITE) OR RSS-Gen,
Issue 5 – General Requirements for Compliance of Radio Apparatus and RSS-247, Issue 2 -
UN38.3 Rev. 6, T.7
WARNING
CAUTION