Users Manual

Initialisation Device Charger
Instructions for Use
Copyright © 2020 STRYDE All rights reserved
4
1. Safety Information
The following general safety precautions must be observed during all phases of operation of
this product.
Do not use the device if it appears damaged or defective
Do not perform any unauthorized modification or change to the
device
Do not expose to excessive heat or flames
Dropping the device and other mechanical abuse may cause damage to
the electronics and mechanical parts
The device shall only be serviced by trained personnel who are familiar
with the STRYDE system.
Failure to comply with these precautions or with specific warnings elsewhere in this manual
violates safety standards of design, manufacture, and intended use of the product. STRYDE
assumes no liability for the customer’s failure to comply with these requirements.
For further information on safety, please refer to the STRYDE Operation Support Product File.
2. Certifications
This product is designed for use in compliance with, and is certified according to, the following
certification rules:
FCC Part 18.305
FCC Part 15.209
General Requirements for Intentional Radiators
ETSI EN 303 417 V1.1.1 (2017-09)
ETSI EN 303 446-1:V1.2.0 (draft – 2019-03)
FCC KDB 680106 D01 RF Exposure Wireless Charging Apps v02
FCC Part 1.1310 Radiofrequency radiation exposure limits
EN 301 489-01:V2.2.0
EN 301 489-03:V2.1.1
EN 303 446-1:V1.2.0 (draft)
EN 61000-6-2:2005
EN 61000-6-3:2007 + A1:2011
IEC 61010-1:2010, AMD1:2016
WARNING
CAUTION