STRYDE Initialisation Device Charger Instructions for Use INITIALISATION DEVICE CHARGER INSTRUCTIONS FOR USE Document Number: 0000000079 Date: 21st July 2020 Revision: A Copyright © 2020 STRYDE All rights reserved
Initialisation Device Charger Instructions for Use Copyright © 2020 STRYDE. All rights reserved. INTELLECTUAL PROPERTY No part of this publication may be reproduced, transmitted, transcribed, stored in a retrieval system, or translated into any language or computer language in any form or by any means, electronic, mechanical, magnetic, optical, chemical, manual, or otherwise, without prior written permission of STRYDE. Copyright violators also may be subject to civil penalties.
Initialisation Device Charger Instructions for Use Table of Contents 1. Safety Information ____________________________________________________ 4 2. Certifications _________________________________________________________ 4 3. Introduction __________________________________________________________ 5 4. Product Overview _____________________________________________________ 5 5. Technical Specifications ________________________________________________ 5 6.
Initialisation Device Charger Instructions for Use 1. Safety Information The following general safety precautions must be observed during all phases of operation of this product.
Initialisation Device Charger Instructions for Use 3. Introduction This manual describes the necessary safety precautions and gives a brief overview of the functionality of the Initialisation Device Charger, also referred to as the Charger Carrier. The STRYDE system is a seismic acquisition system for professional use, and the Charger Carrier is used to recharge the batteries of the Initialisation Device in this system.
Initialisation Device Charger Instructions for Use charge the Initialisation Devices used by the crews during deployment and retrieval of the seismic Nodes. Initialisation Devices shall be inspected for damage before charging, damaged units shall be decommissioned when returned to the local operations hub. Initialisation Devices should be clean and dry before charging with the Initialisation Device Charger.
Initialisation Device Charger Instructions for Use 11. End of Life This product shall be safely disposed of as electronic waste. The owner of the system is responsible for disposal in accordance with local laws and regulations at the time it is disposed of. The unit contains recyclable materials and they should be recycled where facilities are available. Ultimate disposal of this product should be handled according to all national laws and official regulations.
Initialisation Device Charger Instructions for Use 14. Compliance Statement This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
