Product Manual

Page 9 of 14
49509, 1” Sprinkler
The sprinkler head is a fully adjustable sprinkler that will operate in a full circle pattern or any part of a
circle pattern by adjusting the stops at the base of the head. Refer to the instructions below to set the
sprinkler head to the desired operating pattern.
For full circle operation, loosen the sprinkler stops and slide the
stops all the way down the brass sprinkler base so they do not
contact the reverse lever on the back of the sprinkler head as
shown at right. Re-tighten the set screws to hold the stops in place.
This will allow the sprinkler head to operate in a full-circle mode.
For part circle operation, loosen the sprinkler stops and raise the
stops so they will contact the reverse lever on the back of the
sprinkler head as shown at right. Re-tighten the set screws to hold the
stops in the desired sprinkling angle. This will allow the sprinkler head
to operate in a part-circle mode.