Product Manual

Page 10 of 14
49521/49522, 1-1/4” Sprinkler
The sprinkler head is a fully adjustable sprinkler that will operate in a full circle pattern or any part of a
circle pattern by adjusting the stops at the base of the head. Refer to the instructions below to set
sprinkler head to the desired operating pattern.
For full circle operation, loosen sprinkler stops and slide stops all the
way down the brass sprinkler base so they do not contact the reverse
lever on the back of the sprinkler head as shown at right. Re-tighten the
set screws to hold the stops in place. This will allow the sprinkler head
to operate in a full circle mode.
For part circle operation, loosen the sprinkler stops and raise the stops
so they will contact the reverse lever on the back of the sprinkler head
as shown at right. Re-tighten the set screws to hold the stops in the
desired sprinkling pattern. This will allow the sprinkler head to operate
in a part circle mode.
After Each Use
After use, disconnect the water hose and drain any water in the sprinkler (also drain the hose). Wipe
off the sprinkler to remove any dirt and reduce mineral residue from water drying on the sprinkler.
Store the tool when it is not in use. Store it in a dry, secure place out of the reach of children. Inspect
the tool for good working condition prior to storage and before re-use.