Product Manual

Page 9 of 13
Be sure that both front and rear guard screws are completely tightened in locking position before
operation.
Operating Instructions
This unit is equipped with a speed selector switch, which allows you to select a desired amount of air
delivery.
Speed Control
Select air speed with the pull chain switch: HIGH, MIDDLE, LOW, OFF (3-speed control) or HIGH,
LOW, OFF (2-speed control).
Maintenance
1. Use a soft damp cloth, then wipe with dry cloth.
2. The motor bearings are lubricated at the factory and should not require any additional lubrication.
However, if bearing lubrication is required, apply a small amount of a high temperature bearing
grease.
3. Use a mild detergent to clean blades and guards. Avoid allowing the cleanser to come in contact
with the motor bearings or windings.
4. Allow fan to completely dry before next use.
⚠WARNING
 Disconnect power before servicing.
 Use OSHA approved lock-out tag-out devices on power supply to prevent shock and/or
electrocution.
Parts Diagram