Manual

Page 10 of 14
Assembly
1. Mark the desired hole locations by using the wall bracket, then drill holes.
2. For concrete wall installation; after drilling, insert the wall anchors and tap them flush with
the wall, position the bracket and then screw the two bolts into the anchors, securely
attaching to the wall.
3. For wall stud installation; after drilling the smaller diameter pilot hole, position the bracket
and screw the two bolts into the wall until they are secured.
Caution: the fan is only suitable for concrete wall and wall stud. Do not use dry wall mounting. Use the
mounting accessories shipped with products for wall mounting.
12in.18in.and 24in.
Before Each Use
Place the fan on a safe, flat surface where it cannot fall or be pulled by the cord.
Operating Instructions
1. Connect power plug to any standard 120V AC outlet. Caution: Make sure Control is in the “0”(off)
position.
2. The fan (49886 & 49887）comes with three different speeds. The fan (49888) comes with two
different speeds. Pull power chain once to operate the Low speed and allow to operate for 10
seconds. Once 10 seconds have passed , you may now pull the power chain to the Med or High
position.
After Each Use
Always turn off (0-Off) and unplug fan after using.