Product Manual

Page 8 of 14
Assembly Instructions
1. Unpack and inspect the cord reel for damage. Pull and relax the cord to check for a smooth
operation. Check that the cord reel is able to completely retract.
2. The cord reel must be installed in locations conforming to current regulation and standards
covering systems and work environments.
3. Secure the cord reel to the wall and the ceiling according to the installation diagram using screw
anchors or screws. They must fit in the ø8.5mm holes of the brackets.
4. Adjust the cable stopper to the correct position when required.
Operating Instructions
⚠WARNING
 Electric shock hazard. Do not use the cord reel in damp or wet conditions.
 For indoor use only.
 To avoid damage to the cord reel, always hold on to the cable while it is rewinding.
1. Check the cord reel for correct operation by slowly pulling out the cable.
2. To latch the cord reel, slowly pull out the cable to any point and relax it to stop.
3. To unlatch the cord reel, slowly pull the cable after it’s relaxed and let the cable retract until it
rests against the cable guide.
4. When over loading, the thermal cut-out will cut off automatically stop. You should then push the
red button until it resets.