Product Manual

Page 6 of 10
flange and are secure. Adjust if necessary.
 Only use on a flat, level surface.
 Do not use to lift people or animals.
 Not for use by or around children.
Operating Instructions
⚠WARNING
 Beam must be properly installed and rated for anticipated loads.
 Do not install trolley on beams of unknown capacity.
 Do not install trolley on damaged or deformed beams.
 Trolleys are designed to be used with hoists of the same rated capacity. Never use a hoist with a
capacity greater than the capacity of the trolley.
 Never subject trolley to a side pull or load. Load must be centered directly under the hoist / trolley
assembly.
 Make sure the load is stable and secure before moving.
1. Measure the actual width of the “I” type beam
2. The width between the wheels should be 6mm wider than the width of the “I” type beam.
3. While using the trolley on the smallest size “I” type beam, move the equalizer pin to the opposite
side of the chain to balance the trolley.
4. During operations, the trolley should not move too fast and should not be overloaded.
Maintenance
Maintain the trolley by adopting a program of conscientious repair and maintenance in accordance
with the following recommended procedures. It is recommended that the general condition of any tool
be examined before it is used. Keep your tool in good repair. Keep handles dry, clean, and free from
oil and grease. The following chart is based on a normal operation schedule.