Product Manual
Page 12 of 17
⚠CAUTION
EQUIPMENT DAMAGE
Use only the supplied boost cables to boost a vehicle or boat engine that has a 12V starting
battery.
Ensure that the powerpack is placed away from the moving parts of the engine and powerpack
power ON/OFF switch is in OFF position.
Make sure the cable clamps are connected correctly to the battery terminals. A reversed polarity
connection (positive to negative) may cause a spark and damage the equipment. If the cable
clamps are connected in reverse, the reverse polarity LED indicator glows red and the audible
alarm will sound.
Using the Air Compressor
⚠WARNING
The compressor is designed for short term operation only. Operating the compressor over an
extended period of time will cause the compressor unit to overheat, which could lead to fire. Allow
the compressor to cool down for 10 minutes after each 10 minutes of continuous operation.
Do not leave the compressor unattended while in operation Keep out of children.
Do not exceed the recommended pressure of either the compressor or the object being inflated.
The compressor is capable of inflating to 260PSI. If the rated pressure is exceeded, an explosion
may occur.
If the powerpack shuts off due to an over-temperature condition, turn OFF the air compressor
switch and allow the compressor to cool down for 15 minutes before re-starting.
The powerpack cannot be used to inflate large capacity inflatables such as float tubes, large air
mattresses, transport truck tires, and inflatable boats. These types of products require extended
inflating time which may damage the compressor.
Not for use by or around children.
Inflating Vehicle, Motorcycle, and Bicycle Tires
1. Check battery capacity status by pressing any button on the right of the LCD screen, to ensure
that the battery is fully charged.
2. Uncoil the compressor hose from unit.
3. Ensure the locking lever of the valve connector is fully extended.
4. Remove the valve cap from the valve stem of the tire.
5. Latch the valve connector firmly and completely over the valve stem and push down on the
locking lever so that it locks onto the valve stem.
6. If you do not need to preset the PSI, press the top left compressor ON/Off button to start working.
7. If you would like to preset the pressure on the LCD screen, please press the “SET” button, then
press up or down arrow to adjust PSI.
8. Press the “SET” button again to start inflating. Air compress will stop when reach the desired PSI.
NOTE: If the tire is not inflated to the desire pressure after 10 minutes, turn the air compressor off and
allow it to cool for 10 minutes before resuming inflation.