Product Manual

Page 7 of 12
3. Prepare the back-plate for mounting by drilling out the two corners and centering the (5/16’’
diameter) holes (B).
4. If the wiring is performed using a recessed junction box then drill out the appropriate junction box
holes.
5. Line up the back plate to the desired location and mount it securely. Use the supplied gaskets for
a weather-tight seal between the back plate and the junction box.
6. Attach the driver input wires to the color matched supply wires.
7. Place the front housing assembly on the hinge pins of the back plate.
8. Plug the male connector of the LED board into the female connector of the driver.