Product Manual

Page 10 of 15
• Do not use this fan with any solid-state speed control device.
• Only plug the unit into a power outlet with the same voltage as rated voltage of it.
• Rotating blade hazard. Keep hands clear to avoid serious injury.
• Do not operate in the presence of explosive and/or flammable fumes.
• Do not plug/unplug the fan into/from the electrical outlet while wet or standing in a wet or damp
area.
• Never operate the fan without the guard in place.
• For indoor use only. Do not use outdoors. Do not place the fan in or near a window. Rain may
create an electrical hazard.
• Do not operate any fan with a damaged cord or plug. Discard fan or return to an authorized
service facility for repair before resuming operation.
• Do not run cord under carpeting. Do not cover cord with throw rugs, runners, or similar coverings.
• Do not place cord under furniture or appliances. Arrange cord away from a higher traffic area and
where it will not be tripped over.
1. Plug fan into grounded power outlet.
2. Direct fan to area of desired air flow. Select speed for cooling.
To Adjust Airflow Upward or Downward
Loosen the POSITION SCREW first, tilt fan head to desired angle, and then loosen the pivot bolt of
the INNER TUBE. Tilt fan head to the desired angle, firmly tighten the POSITION SCREW, and
tighten the PIVOT BOLT of the INNER TUBE.
To Oscillate the Fan
Loosen the screw on the oscillation rod and move to the end of the oscillation cam. Tighten the screw
to lock the position (Figure 1).
To Stop the Oscillation
Loosen the screw on the oscillation rod and move it to the center of the oscillation cam. Tighten the
screw to lock the position (Figure 2).
Speed Control
Select air speed by setting switch to HIGH, LOW, or OFF.