Product Manual

Page 6 of 13
 Make sure this is clear of obstacles such as cables and electric lines.
 Secure the lamp to the wall with the screws provided.
 Carefully route the wire from the solar panel to the lamp and plug it into the battery
housing input.
 Adjust the motion sensor so that it faces the area where motion detection is desired. You
can move it up and down by adjusting the screw on the neck of the motion detector.
Note: The lamp unit should be mounted 6 – 10 feet from the ground to ensure motion detection is
optimized
2. Wall or Deck Mounting:
 Secure the bracket to the solar panel with the screw provided, as shown below.
 Set the bracket on the surface and secure in place with the larger screws provided.
 Adjust the angle of the solar panel to ensure it receives optimum sunlight.
Note: The solar panel is equipped with a specific length of wire. Ensure that the wire will reach the
desired position of the lamp before making the final installation.