Product Manual

Page 7 of 12
The TIME dial sets the duration the light will stay on when triggered. The duration is adjustable from 5
seconds to 2 minutes. Rotating the dial clockwise will
increase the duration the light will stay on.
SENS (Sensitivity)
The SENS dial adjusts the sensitivity of motion
detection:
1. Minimum position – Low Range: large movement is required to trigger the light to turn on.
2. Mid Position - Medium setting.
3. Maximum position - Maximum range: the smaller movements will trigger the light to turn on.
Location of Solar Light
Solar powered lights require sunlight to recharge the internal batteries. For best results, locate the
solar panel in a position where it will receive direct sunlight, and is generally free from cover and
shade.
Maintenance
Maintain the solar powered light by adopting a program of conscientious repair and maintenance in
accordance with the following recommended procedures
Maintenance Interval
Maintenance Point
First Use
Allow the solar panel to charge the light for two sunny days.
Observe the solar panel once installed for one day. Ensure
that it is not shaded at any time during daylight.
Observe the light once installed during the evening. Ensure
there is no alternate light source that will interfere with the
light’s sensors.
Seasonally
Visually inspect the solar panel and light to ensure both are
clear of debris and dirt.
Observe the solar panel during one sunny day to ensure that
as the suns position has changed in the sky, the solar panel is
still receiving optimal sunlight throughout the day.
During the Winter
Check the solar panel. Ice should not be allowed to form on
the solar panel as the freezing can damage waterproof seals.
Adjust the angle of the solar panel to the sun’s lower position
in the sky. This will maximize the amount of sunlight received
and help allow any water or snow that accumulates on the
panel to slide off.