Product Manual

Page 6 of 12
• Adjust the motion sensor to your desired position. Your light is now installed and ready to
charge.
Note: The lamp unit should be mounted 6.5 ~ 9.8 feet from the ground to ensure motion detection is
optimized.
2. Solar Panel Wall or Roof Mounted Installation
• Choose an area that receives the maximum amount of sunlight possible.
• Use the holes located on the solar panel mounting bracket to mark the mounting surface for
installation.
• Set the bracket on the surface you have chosen and secure it in place with the screws and
anchors provided.
• Adjust the angle of the solar panel to ensure it receives optimum sunlight.
Note: The solar panel is equipped with a 15 foot wire. The maximum distance between the lamp unit
and solar panel can be 15 feet.
Before Each Use
⚠WARNING
Solar lights require sunlight to function properly. Extended periods of cloudy weather will cause
shorter run-times. Shade on the solar panel is to be avoided. The solar panel may be cleaned with a
clean damp cloth. Do not use soap, solvents, or abrasives.
A regular visual inspection is recommended. Ensure the solar panel is free from debris and in a
location where it will receive several hours of sunlight each day. Ensure the light is facing the desired
direction and that there are no nearby alternate light sources that may interfere with the motion
sensor.
Operating Instructions
1. Before the Solar Motion Light can operate to its full capacity, allow the unit to charge in sunlight
for 3 days with the solar panel wire connected to the light. Charging should be done with the unit
in the “OFF” position.
2. Located at the bottom of the Battery Housing there is an OFF/AUTO/ON switch:
• “AUTO” position, the light will turn on automatically when motion is detected.
• “ON” position, the light can be used as a standard light for constant illumination.
• “OFF” position, the light will remain off and will not detect any movement.
How to Use Control Dials
The Solar Motion Light has 3 dials which control the light’s duration,
sensitivity to light, and sensitivity to motion.
LUX (Light Level)
The LUX dial adjusts the sensitivity to darkness. If set to the maximum
level, the light will go on in daylight. If set to the minimum level ,
the sensor will only trigger the light to turn on at dusk or when it is dark
out. This is the ideal position for general usage. Please note that
ambient light will affect the sensor.
Time