Product Manual

Page 5 of 12
handle the solar powered light.
 Be aware of all power lines, electrical circuits, water pipes, and other mechanical hazards in your
work area. Some of these hazards may be hidden from your view and may cause personal injury
and/or property damage if contacted.
⚠WARNING
PERSONAL SAFETY
 Stay alert, watch what you are doing, and use common sense when operating the tool. Do not
use the tool while you are tired or under the influence of drugs, alcohol, or medication. A moment
of inattention while operating the tool may result in serious personal injury.
 Dress properly. Do not wear loose clothing, dangling objects, or jewelry. Keep your hair, clothing
and gloves away from moving parts. Loose clothes, jewelry, or long hair can be caught in moving
parts. Air vents on the tool often cover moving parts and should be avoided.
 Wear the proper personal protective equipment when necessary. Use ANSI Z87.1 compliant
safety goggles (not safety glasses) with side shields, or when needed, a face shield. Use a dust
mask in dusty work conditions. Also use non-skid safety shoes, hardhat, gloves, dust collection
systems, and hearing protection when appropriate. This applies to all persons in the work area.
 Do not overreach. Keep proper footing and balance at all times.
 Ensure the power switch is off prior to plugging in the tool.
⚠CAUTION
LIGHT USE AND CARE
 Do not use a product with a malfunctioning switch. Any power tool that cannot be controlled with
the power switch is dangerous and must be repaired by an authorized service representative
before using.
 Disconnect the power/air supply from the product and place the switch in the locked or off position
before making any adjustments, changing accessories, or storing the tool. Such preventive safety
measures reduce the risk of starting the tool accidentally.
 Use only accessories that are recommended by the manufacturer for use with your product.
Accessories that may be suitable for one product may create a risk of injury when used with
another tool. Never use an accessory that has a lower operating speed or operating pressure than
the tool itself.
Assembly Instructions
1. Lamp Unit Installation
• Mounting your light requires a screwdriver, pencil, and (in some circumstances) a power drill.
• Place the mounting bracket on the surface you wish to mount to.
• Mark with a pencil the position of the mounting bracket screw holes. This will enable you to
pre-drill your screw holes.
• Once the mounting bracket is installed, ensuring all screws are tight, you are ready to position
your light.
• Carefully route the wire from the solar panel to the lamp and plug it into the power socket.