Product Manual

Page 9 of 16
Adjusting the Control Handle – 3 Positions
On the Handle Tube (1) of this pallet truck, you can find the Control Lever (5), which can be placed in
three positions (See Fig. 3):
LOWER - to lower the load, pull up on the control lever.
NEUTRAL - place the control lever in this position while pulling the truck or load.
LIFT - to raise the load, push down on the control lever and pump the handle to raise the load.
Fig. 3
NOTE: The numbers in parentheses refer to part numbers in the breakdown.
NOTE: These three positions have been set at the factory to work appropriately as soon as the
handle tube is attached. Check to see if the pallet jack works well in the 3 control positions. If the forks
do not raise or lower as expected, proceed to the following steps (Fig. 4):
1. Pull the Control Lever (5) upward to the "LOWER" position. If the Fork Frame does not
lower, turn the Nut (13) CLOCKWISE until the Fork Frame lowers.
2. Push the Control Lever (5) down to the "LIFT" position. If the fork frame does not elevate,
turn the Nut (13) COUNTER-CLOCKWISE until the Fork Frame elevates.
3. Keep the control handle in the "NEUTRAL" position. If the Fork Frame lowers, turn the Nut
(13) COUNTER-CLOCKWISE until the Fork Frame does not lower.
4. Check again to see if the pallet jack works well in the 3 control positions. If not, repeat the
steps above until the pallet jack works well.
Fig. 4
Lower
Neutral
Lift