Product Manual

5. Aim the pushing end towards the area that needs to be repaired and slowly apply pressure with the

Pump Unit. Once contact has been made on both points of contact, step away as far as possible and

continue to slowly apply pressure to the damaged area until the desired bend has been made.

6. When the damaged area has been bent to the desired position, slowly turn the Release Valve on the

Pump Unit in a counter-clockwise direction to release the hydraulic pressure and remove the

Hydraulic Ram.

Example: To Use the Spreader Wedge

1. Determine which direction part needs to be bent.

2. Remove any obstructions that could be damaged or are in the way.

3. Place Spreader Wedge so that the hinged arm is resting against the part to be moved and the

stationary arm is resting against a non-movable base. Hold the Spreader Ram in position and apply

the Pump Unit pressure. Once contact on either end has been made, step away as far as possible

and continued to slowly apply pressure to the damaged area until the desired bend has been made.