Product Manual

SINGLE SWING GATE OPENER
OWNER’S MANUAL
SINGLE SWING GATE OPENER
OWNER’S MANUAL
3. Connect the AC power supply cable to the control box as shown in the following illustration:
4. Connect the motor power cable to the control box as shown in the following illustration.
Note: Pull-to-Open and Push-to-Open use different wiring schemes.
Step 6 — Program the Remote Control
WARNING: Activate the gate opener only when gate is in full view, free of
obstruction, and properly adjusted. No one should enter or leave the gate area while
the gate
is in motion. Do not allow children to operate the remote control. Do not allow children to
play near the gate.
Both the standard 2 remote controls and the additional purchased one, you need learn first
before it can be used to control the gate opener.The gate opener can learn the commands of up
to six remote controls.
Please see below how to learn the remote control.
To erase all remote control commands: Press and hold the learn button until the LED display
“dL”,release the learn button the LED will display "- -". Now all remote codes have been erased.
Notes
• The maximum distance from which the remote control can operate the gate opener is 100 ft.
• The control box must be located so that transmission of signals are not obstructed or
impeded by building structures, natural landscaping, or similar obstruction.
16 of 26 17 of 26
RED to MOTOR1+
BLACK to MOTOR1–
BLUE to ULT1
GREEN to COM
YELLOW to DLT1
Pull-to-Open Push-to-Open
BLACK to MOTOR1+
RED to MOTOR1–
YELLOW to ULT1
GREEN to COM
BLUE to DLT1