Product Manual

DUAL SWING GATE OPENER
OWNER’S MANUAL
1. Insert the AC power supply cable (not supplied) and one of the motor power cables (supplied)
through the left strain relief and into the control box by loosening the strain relief screw
located on the bottom of the control box and feeding the cables into the control box. Make
sure that the cables reach the proper terminals in the control box. Tighten the sealing nut so
that the cables are well secured.
Insert the other motor power cable (supplied) through the right strain relief and into the
control box by loosening the strain relief screw located on the bottom of the control box and
feeding the cable into the control box. Make sure that the cable reaches the proper terminals
in the control box. Tighten the sealing nut so that the cables are well secured.
2. Connect the AC power supply cable to the control box as shown in the following illustration:
16 of 26 17 of 26
DUAL SWING GATE OPENER
OWNER’S MANUAL
3. Connect the motor power cables to the control box as shown in the following illustration.
Note: Pull-to-Open and Push-to-Open use different wiring schemes.
Step 6 — Program the Remote Control
WARNING: Activate the gate opener only when gate is in full view, free of
obstruction, and properly adjusted. No one should enter or leave the gate area while
the gate is in motion. Do not allow children to operate the remote control. Do not allow
children to play near the gate.
Both the standard 2 remote controls and the additional purchased one, you need learn first
before it can be used to control the gate opener.The gate opener can learn the commands of up
to six remote controls.
Please see below how to learn the remote control.
RED to MOTOR1+
BLACK to MOTOR1–
BLUE to ULT1
GREEN to COM
YELLOW to DLT1
Pull-to-Open Push-to-Open
BLACK to MOTOR1+
RED to MOTOR1–
YELLOW to ULT1
GREEN to COM
BLUE to DLT1