Product Manual

DUAL SWING GATE OPENER
OWNER’S MANUAL
DUAL SWING GATE OPENER
OWNER’S MANUAL
6. Mark bolt hole locations on the post for the Post Bracket Assembly and on the gate for the
Gate Bracket by placing a mark on the post and gate through the center of each slot in the
brackets.
7. Remove the Post Bracket Assembly and the Gate Bracket by taking off the C-clamps.
8. Drill 10.5 mm or 7/16 inch diameter holes through the post and the gate at the marked
locations.
9. Attach the Post Bracket Assembly to the gate post by inserting four M10 x 200 bolts through
each Post Bracket and the drilled holes in the gate post. Fasten each bolt with one M10
washer, one M10 lock washer, and one M10 nut.
10. Attach the Gate Bracket to the gate by inserting two M10 x 75 bolts through the Gate
Bracket and the drilled holes in the gate. Fasten each bolt with one M10 lock washer, and
one M10 nut.
11. Cut off any part of the bolts that extend beyond the tightened nuts.
12. With the gate opener fully retracted and with the gate in the fully open position (for
Pull-to-Open installation) or fully closed position (for Push-to-Open installation), attach the
gate opener to the Post Bracket Assembly and the Gate Bracket by inserting a clevis pin
through the gate opener and the Post Pivot Bracket and another clevis pin through the gate
opener and the Gate Bracket. Secure each clevis pin with a hairpin clip.
13. Open the release hole plug on the top of the gate opener, insert the release key, and turn
the key 90° counterclockwise. This restores normal operation.
12 of 26 13 of 26