Product Manual

DUAL SWING GATE OPENER
OWNER’S MANUAL
DUAL SWING GATE OPENER
OWNER’S MANUAL
1. Place the Post Pivot Bracket between the two Post Brackets. Insert the M10 x 30 bolt
through the center hole of the Post Bracket and Post Pivot Bracket as shown. Place an M10
washer, M10 lock washer and M10 nut on the bottom of the bolt and hand tighten.
2. Attach the Post Bracket Assembly and the Gate Bracket to the gate opener with the clevis
pins. Secure the clevis pins with the hairpin clips
3. Open the release hole plug on the top of the gate opener, insert the release key, and turn the
key 90° clockwise. This releases the motor and allows the push-pull rod to be manually
extended and retracted. To restore normal operation, turn the key 90° counterclockwise.
4. With the gate opener fully retracted and with the gate in the fully open position (for
Pull-to-Open installation) or fully closed position (for Push-to-Open installation), place the
gate opener with the Post Bracket Assembly and Gate Bracket on the gate post and the gate.
Position the Post Bracket Assembly and Gate Bracket so that the gate opener is level. While
holding the gate opener in the level position, temporarily secure it with two C-clamps.
5. Make sure that there is a minimum clearance of 1" between the gate and the gate opener and
that the gate opener and the Post Pivot Bracket are not binding. If there is not at least 1"of
clearance or if the gate opener and the Post Pivot Bracket are binding, rotate the Post Pivot
Bracket and/or move the Post Bracket Assembly to obtain the minimum clearance and
eliminate the binding. When the minimum clearance has been obtained and any binding has
been eliminated, place the M8 x 30 bolt through the aligned holes in the Post Bracket and the
Post Pivot Bracket.
Remove the clevis pin from the Gate Bracket and move the gate to the gate closed position
(for Pull-to-Open installation) or gate open position (for Push-to-Open installation), fully
extend the gate opener, and reattach the gate opener to the Gate Bracket with the clevis pin.
Repeat the above step to ensure the minimum 1" clearance and that the gate opener and
Post Pivot Bracket are not binding.
When the best position for the Post Pivot Bracket has been obtained, secure it in place with
an M8 washer and M8 nut.
10 of 26 11 of 26