Product Manual

DUAL SWING GATE OPENER
OWNER’S MANUAL
DUAL SWING GATE OPENER
OWNER’S MANUAL
• Use the right tool for the job. DO NOT attempt to force a small equipment to do the work of
larger industrial equipment. There are certain applications for which this equipment was
designed. It will do the job better and more safely at the capacity for which it was intended.
DO NOT use this equipment for a purpose for which it was not intended.
• Check for damaged parts. Before using this product, carefully check that it will operate
properly and perform its intended function. Check for damaged parts and any other
conditions that may affect the operation of this product. Replace damaged or worn parts
immediately. Never operate this product with a damaged part.
• DO NOT overreach. Keep proper footing and balance at all times to prevent tripping, falling,
back injury, etc.
• DO NOT use the equipment when tired or under the influence of drugs, alcohol, or
medication. A moment of inattention while operating this equipment may result in serious
personal injury.
• Industrial or commercial applications must follow OSHA requirements.
• The warnings and instructions in this manual do not cover all possible conditions or
situations that may occur. The user must always be aware of their environment and ensure
that they use the product in a safe and responsible manner.
Safety Labels
Important Installation Safety Instructions
• Install the gate opener only when:
- The gate opener is appropriate for the construction of the gate and the usage Class of the gate.
- All exposed pinch points are eliminated or guarded.
• The gate opener is intended for installation only on gates used for vehicles. Pedestrians must
be supplied with a separate access opening. The pedestrian access opening shall be
designed to promote pedestrian usage. Locate the gate such that persons will not come in
contact with the vehicular gate during the entire path of travel of the vehicular gate.
• The gate must be installed in a location so that enough clearance is supplied between the
gate and adjacent structures when opening and closing to reduce the risk of entrapment.
• The gate must be properly installed and work freely in both directions prior to the installation
of the gate opener. Do not over-tighten the gate opener clutch or pressure relief valve to
compensate for a damaged gate.
• Controls intended for user activation must be located at least ten feet (10’) away from any
moving part of the gate and where the user is prevented from reaching over, under, around or
through the gate to operate the controls. Outdoor or easily accessible controls shall have a
security feature to prevent unauthorized use.
• The Stop and/or Reset button must be located in the line-of-sight of the gate. Activation of the
reset control shall not cause the gate opener to start.
• A minimum of two (2) WARNING SIGNS (included) shall be installed, one on each side of the
gate where easily visible.
4 of 26 5 of 26