Product Manual

ADDITIONAL OPERATING INSTRUCTIONS:

To remove an auto or truck engine with transmission intact, first uncouple the transmission

and remove motor mount bolts. With the Engine Leveler hooked to an overhead hoist above

the engine, attach the L-shape connections at the end of the four (4) chains (choose one of

two holes provided) to the engine head bolts - two at front, both sides, and two at rear, both

sides. Using the engine hoist, take up slack in chain carefully. lift a few inches and check

load balance. To reach the desired angle for load balance, adjust the position of the

movable fulcrum in the beam by turning the handle or the 1" hex adjusting nut at end of the

worm shaft with a ratchet wrench. Then carefully lift out the engine and transmission. By

turning the handle one direction or the other, the suspended engine and transmission can

then be tipped only enough to remove. Reverse the above steps to reinstall repaired engine

transmission. For this and other types of loads, make sure all connections are tight and

secure before operating the hoist.