Product Manual

Page 12 of 18
As always, be careful while working.
Grinding
1. With the clamping screw adjusted, the vise angle set up (Note: RH and LH teeth to be
differentiated), and the top plate angle preset, lower the grinding disc to the tooth. The grinding
depth may reset by adjusting the set screw (K).
2. Some types of chains require that the clamping screw be tilted by 5°-10°.
3. Now, the machine may be switched on and the chain grinding may be started by gently
pressing the disc on the chain. Adjust the pressure as necessary. Mark the start of the grinding
with a piece of chalk and grind all the teeth in one direction, then turn the clamping screw
(mind the angle) and grind the teeth in the opposite direction.
4. With worm chains, the lateral guide position (Fig.10, Position M) should be set so the grinding
disc doesn’t touch the guide.
After Each Use
⚠WARNING
 Keep the sharpener clean, especially after grinding, and check for any damage.
 Do not use a caustic solution to clean plastic parts.
 Do not use the sharpener in the proximity of flammable liquids and vapors.