Product Manual

Page 9 of 18

The hoist may be mounted on a fixed overhead pipe or beam.

1. Place the two hanging clamps (reference 8) over the supporting structure where the hoist will be

mounted. Have a person or two help hold the hoist in position under the hanging clamps so the

hoist is aligned with the holes in the hanging clamps.

2. Tighten the screws (reference 2) when the hoist is at a suitable position.

Before Each Use

⚠WARNING

 CHECK FOR DAMAGED PARTS. Before using any tool, any part that appears damaged should

be carefully checked to determine that it will operate properly and perform its intended function.

 WIRE ROPE. Be sure the wire rope is in good condition and is attached properly.

 POWER SUPPLY. Be sure the power cord and control handle are in good condition.