Product Manual

Page 12 of 18

2. Place the pulley hook (69) assembly (without the hook attached) onto the wire cable below the

line blocker. Make sure the pulley hook roller is aligned on the wire cable (19) and is not in any

way askew or oblongly seated on the wire.

3. Slide the bolt (71 & 72) back into the pulley (69), hook and all washers (80 & 81). Tighten the nuts

(75 & 76). See the illustration above.

Emergency Stop Switch

If an emergency occurs, press the emergency stop switch (83) immediately.

After Each Use

⚠WARNING

 DO NOT store the wire rope where it can be of any harm.

Store the electric wire rope in a dry and clean place for the next use.

Lubricate the rope occasionally with light oil. Check that it is in good condition.