Product Manual

Page 12 of 19
1. Remove the washers (81), nuts (75 & 76), and bolts (71 & 72) from the pulley.
2. Place the pulley hook assembly (69) (without the hook attached) onto the wire cable below the
line blocker. Make sure the pulley hook roller is aligned on the wire cable (19) and is not in any
way askew or oblongly seated on the wire.
3. Slide the bolt (71 & 72) back into the pulley (69), hook, and all washers (80 & 81). Finally, tighten
the nuts (75 & 76). See the previous illustration.
69
19