Product Manual

SAVE THESE INSTRUCTIONS
Operating Instructions
1. Before the light can operate to its full capacity, allow the unit to charge in sunlight for 3 days with the solar
panel wire connected to the light. Charging should be done with the unit in the “OFF” position.
2. Located at the bottom of the Battery Housing there is am OFF/AUTO/ON switch:
 “AUTO” position, the light will turn on automatically when motion is detected.
 “ON” position, the light can be used as a standard light for constant illumination.
 “OFF” position, the light will remain off and will not detect any movement.
How to Use Control Dials
The light has 3 dials which control the light’s duration, sensitivity to light and
sensitivity to motion.
LUX (Light Level)
The LUX dial adjusts the sensitivity to darkness. If set to the maximum level, the
light will go on in daylight. If set to the minimum , the sensor will only trigger the
light to turn on at dusk or when it is dark out. This is the ideal position for general usage. Please note that
ambient light will affect the sensor.
Time
The TIME dial sets the duration the light will stay on when triggered.
The duration is adjustable from 8 seconds to 2 minutes. Rotating the dial clockwise will increase the duration
the light will stay on.
SENS (Sensitivity)
The SENS dial adjusts the sensitivity of motion detection:
1. Minimum position – Low Range: large movement
is required to trigger the light to turn on.
2. Mid Position - Medium setting.
3. Maximum position - Maximum range: the smaller movements will trigger the light to turn on.