Product Manual

SAVE THESE INSTRUCTIONS
 Make sure this is clear of obstacles such as cables and electric lines.
 Secure lamp to the wall with screws provided.
 Carefully route the wire from the solar panel to the lamp and plug it into the battery housing input.
 Adjust the motion sensor so that it faces the area where motion detection is desired. You can move it
up and down by adjusting the screw on the neck of the motion detector.
Note: Lamp unit should be mounted within 6 to 10 feet from the ground to ensure motion detection is
optimized.
2. Wall or deck mounting of solar panel
 Secure bracket to solar panel with screw provided as shown below.
 Set bracket on surface and secure in place with larger screws provided.
 Adjust angle of solar panel to ensure it receives optimum sunlight.
Note: The Solar Panel is equipped with a length of wire. Ensure that the wire will reach the desired position of
the lamp before making final installation.
Before Each Use
⚠WARNING
Solar lights require sunlight to function properly. Extended periods of cloudy weather will cause shorter
runtimes. Shade on the solar panel is to be avoided. The solar panel may be cleaned with a clean,
damp cloth. Do not use soap, solvents, or abrasives.
A regular visual inspection is recommended. Ensure the solar panel is free from debris and in a location
where it will receive several hours of sunlight each day. Ensure the light is facing the desired direction and
that there are no nearby alternate light sources that may interfere with the motion sensor.