Product Manual

Page 8 of 12
Extending the Webbing
• Secure the hooks and pulley to a rigid anchor. Press the drive pawl switch in the position shown
below (A).
• Depress the stop pawl in the direction of the arrow below (B).
• At the same time, pull the webbing until the desired slack is obtained.
Raising Loads or Applying Tension
• Engage the drive pawl and ratchet wheel. The position of the switch is shown below (A).
• Operate the handle in the direction of the arrow (B). Each stroke of the handle will wind the
webbing to pull the load.
After Each Use
• Always store the strap puller in a safe, dry place when it is not in use.
• Inspect the tool for good working condition prior to storage and before re-use.
⚠WARNING
• Remove any load before performing any inspection, maintenance, or cleaning procedures.